EU PVSEC Programme Online
EU PVSEC 2021, 6 - 10 September 2021
Session: 4AV.2 PV Module Characterisation, Testing and Outdoor Performance
Type: Visual
Date: Monday, 6th September 2021
17:00 - 18:30
Event: Conference Conference
Topic: 4. Photovoltaic Modules and BoS Components
4AV.2.1 Outdoor Photoluminescence and Electroluminescence Imaging of Silicon Modules in a String
I. Burud, NMBU, Ås, Norway
4AV.2.2 Investigations on the Temperature Dependency of the Shunt Resistance in CIGS Thin-Film Solar Modules Using Dark IV-Curve Measurements
L. Gerstenberg, Nordhausen University of Applied Sciences, Nordhausen, Germany
4AV.2.3 Complete Recovery of Crystalline Silicon Photovoltaic Modules by the Early Detection of Potential Induced Degradation
M. Florides, University of Cyprus, Nicosia, Cyprus
4AV.2.4 LeTID: Electrical Parameters Trend of Bifacial Silicon Modules Using Accelerated Aging Tests and Statistical Modelling
G. Plessis, EDF R&D, Moret-sur-Loing, France
4AV.2.5 Potential Induced Degradation (PID) Free Module Design via Interruption of the Electric Field
K. Sporleder, Fraunhofer IMWS, Halle (Saale), Germany
4AV.2.6 Accurate Short-Circuit Current Measurements on Photovoltaic Modules – Challenges for On-Site Outdoor Determinations
D. Daume, Coburg University of Applied Sciences, Coburg, Germany
4AV.2.7 Calculation of the Short-Circuit Current of Colored BIPV Modules under Field Conditions by Application of Spectrally and Angle Resolved Measurement Data
L. Clasing, Cologne University of Applied Sciences, Cologne, Germany
4AV.2.8 Impact of Encapsulant Color on the Performance of PV Modules under Desert Conditions
B. Aldalali, Kuwait University, Safat, Kuwait
4AV.2.9 The Impact of Real Albedo Values on Energy Estimation for Bifacial Modules
S. Dittmann, Anhalt University of Applied Sciences, Köthen, Germany
4AV.2.10 Efficiency Loss in Coloured Photovoltaics: Estimating the Contribution from Reflection Loss and Absorption Loss
A. Røyset, SINTEF, Trondheim, Norway
4AV.2.11 Characterization of Low Breakdown Voltage c-Si Solar Cells and Implications on the Annual DC Yield of Partially Shaded c-Si Modules
A. Calcabrini, TU Delft, Delft, Netherlands
4AV.2.12 Rapid Determination of Lateral Non-Uni-Formities of Solar Simulators for PV Modules
M. Meusel, Fraunhofer CSP, Halle (Saale), Germany
4AV.2.13 Angle of Incidence Study at Photovoltaic Modules with Polymer Front Sheet
S. Wendlandt, PI Berlin, Berlin, Germany
4AV.2.14 In Situ Monitoring of Electrical Parameters of PV Modules under Mechanical Stress
T. Duigou, CEA, Grenoble, France
4AV.2.15 Beyond-Standard Equivalent Cell Temperature (ECT) Evaluation
G.H. Yordanov, KU Leuven, Leuven, Belgium
4AV.2.16 Design and Development of Solar Cell Integrated Moisture and Temperature Sensors for Photovoltaic Modules
J.N.B. Patel, Fraunhofer ISE, Freiburg, Germany
4AV.2.17 Temperature Irradiance Matrix for Energy Rating
O. Bazkir, TUBITAK-UME, Kocaeli, Turkey
4AV.2.18 Classification of Uncertain I-V Curves in PV Modules Based on Current and Voltage Evaluation
L. Feng, University of Applied Sciences Bielefeld, Minden, Germany
4AV.2.19 Influence of Light, Temperature and Current on Stabilized Output Power and Energy Yield of CdTe PV Modules
M. Pander, Fraunhofer CSP, Halle (Saale), Germany
4AV.2.21 FTIR Spectroscopy: A Powerful Tool for Photostable Encapsulant Screening
N. Pinochet, CEA, Le Bourget-du-Lac, France
4AV.2.22 Do We Correctly Determine the Power of Thin-Film Modules? Investigation of Stabilization Procedures for Power Determination of Thin-Film Modules
T. Weber, PI Berlin, Berlin, Germany
4AV.2.23 Double-Sided Characterization of Full-Size Bifacial PV Modules Based on Low-Cost LED Bias Light
T.S. Lyubenova, European Commission JRC, Ispra, Italy
4AV.2.24 Photovoltaic Module Performance Measurement Round Robin with Xenon and LED Based Sun Simulators
S. Dittmann, Anhalt University of Applied Sciences, Köthen, Germany
4AV.2.25 Development of Mobile Laboratory for Photovoltaic Testing Service
S.-T. Hsu, ITRI, Hsinchu, Taiwan
4AV.2.26 Analysis of Performance and Deformation for Photovoltaic Module under Different Wind Speeds and Multi-Type Mechanical Loadings
S.-T. Hsu, ITRI, Hsinchu, Taiwan
4AV.2.27 FEM Simulation of Deformations in Strings of Shingled Solar Cells under Mechanical and Thermal Loading
M. Lang, PCCL, Leoben, Austria
4AV.2.29 Multi-Criteria Analysis Method to Evaluate Different Encapsulation Materials for PV Modules and Proposing a Suitable Candidate
H.E. Hayati Soloot, Solar Edition, Oslo, Norway
4AV.2.30 Effects of Work-Shift and Production Line Differences on the Output Performance of an Industrial c-Si PV Module Manufacturing
N.D. Yildirim, Kalyon PV, Ankara, Turkey
4AV.2.31 Thermal Cycle Analysis on Shingled Glass – Glass Samples with SHJ Cells
S. Wendlandt, PI Berlin, Berlin, Germany
4AV.2.32 Enabling Measurement of PV Module Curvature: Towards Characterization of Thermomechanical Residual Stresses
I. Rahmoun, CEA, Le Bourget-du-Lac, France
4AV.2.33 Analysis of the Thermomechanical Behaviour of Concrete Facade Elements with Integrated Photovoltaic Modules
P. Schenk, Fraunhofer CSP, Halle (Saale), Germany
4AV.2.34 Structural Strength Analysis of Double-Glass Photovoltaic Modules Mounted on One-Axis Trackers at Different Boundary Conditions
M.B. Günaydın, Kalyon PV, Ankara, Turkey
4AV.2.35 Spatially Resolved Leakage Current Density in Photovoltaic Modules
H. Nagel, Fraunhofer ISE, Freiburg, Germany
4AV.2.36 Electrical Bias Stabilisation of Power of the Photovoltaic Technologies
A. Mittal, AIT, Vienna, Austria
4AV.2.37 New Developments in Accelerated Weathering Tests for Back-Contact Modules
G.J.W. Meijers, Endurans Solar, Sittard-Geleen, Netherlands