Presentations: |
| 2CV.1.1 Fitting Current-Voltage Curves of Solar Cells with Artificial Neural Networks A. Herguth, University of Konstanz, Konstanz, Germany |
| 2CV.1.2 Long-Term Stability of HJT Solar Cells under Illumination and UV Exposure T. Luka, Fraunhofer CSP, Halle (Saale), Germany |
| 2CV.1.3 Temperature-Dependent Suns-Voc and Suns-iVoc for Advanced c-Si-Based Solar Cell Characterization A.H.T. Le, UNSW Australia, Sydney, Australia |
| 2CV.1.5 High Efficiency Crystalline Silicon Solar Cell Assessment for Tandem Architecture S. Pouliquen, Air Liquide, Palaiseau, France |
| 2CV.1.6 Spectral Multi-Scale Characterization to Assess the Impact of Metallization Bleeding S. Großer, Fraunhofer CSP, Halle (Saale), Germany |
| 2CV.1.7 Rapid Assessment of Optical Properties of Solar Cell Surfaces Using LED Solar-Simulators D. Hevisov, Fraunhofer CSP, Halle (Saale), Germany |
| 2CV.1.8 Simulation of Doping Profile Trade-Off in Thin Emitter Architectures B. Arunachalam, IMEP-LAHC, Grenoble, France |
| 2CV.1.9 EL and LBIC Characterization of Cut Edge Recombination in IBC Solar Cells M. Bokalic, University of Ljubljana, Ljubljana, Slovenia |
| 2CV.1.10 New Device for Accurate Measurement of Busbarless Bifacial Solar Cells by Using N.I.C.E.™ Technology D. Kray, Offenburg University of Applied Sciences, Offenburg, Germany |
| 2CV.1.11 Comparing Microwave Detected Photoconductance, Quasi Steady State Photoconductance and Photoluminiscence Imaging for Iron Analysis in Silicon M. Pengerla, Fraunhofer ISE, Freiburg, Germany |
| 2CV.1.12 6 Decades Research on Photovoltaic Technologies and Characterization in Republic of Serbia I. Batas Bjelic, Institute of Technical Sciences of SASA, Belgrade, Serbia |
| 2CV.1.13 Measuring and Mitigating Edge Recombination in Modules Employing Cut Cells D.D. Tune, ISC Konstanz, Constance, Germany |
| 2CV.1.14 Influence of Injection Level and Wafer Resistivity on Series Resistance of Silicon Heterojunction Solar Cells A. Puaud, CEA, Le Bourget-du-Lac, France |
| 2CV.1.16 Computational Optical Analysis of 3D Modeled Crystalline Silicon Substrates Randomly Textured D.M. Pera, University of Lisbon, Lisbon, Portugal |
| 2CV.1.19 Assessment of Influencing Factors on Lifetime-Based Defect Analysis R. Post, University of Freiburg, Freiburg, Germany |
| 2CV.1.20 A Simplified Double Diode Model for Modeling I-V Characteristic of Si Solar Cells X. Chen, Hohai University, Changzhou, China |
| 2CV.1.22 Spectroscopic Investigation of BO-Related Light-Induced Degradation Defect in Czochralski Silicon A. Meyer, Colorado School of Mines, Golden, USA |
| 2CV.1.23 Revealing the Nano-Scale Structure and Properties of Pinholes in SiOx Layers for POLO Contacts H. Guthrey, NREL, Golden, USA |
| 2CV.1.32 Investigation of Bifacial PERC Cells Based on Rear Side SiOxNy Passivation C.-W. Kuo, TSEC, Hsinchu, Taiwan |
| 2CV.1.33 Innovative Process Control on Premium Technology Photovoltaic Cell and Module Manufacturing Line C. Colletti, ENEL, Catania, Italy |
| 2CV.1.34 Improvement of the Quality of Multicrystalline-Silicon Wafers for the Manufacture of Silicon Heterojunction Solar Cells R. Barrio Martin, CIEMAT, Madrid, Spain |
| 2CV.1.37 The Influence of Pyramid Shapes on the Texturing Quality of Alkaline Etching Processes A. El Jaouhari, RENA, Berg, Germany |
| 2CV.1.38 Ultrasonic-Assisted Chemical Etching (USACE) of Monocrystalline Silicon Wafer with HF-HCl-Cl2 Mixtures A. Stapf, Freiberg University of Technology, Freiberg, Germany |
| 2CV.1.39 Advanced Light-Trapping Structures for Back-Contact Solar Cells Produced by Metal-Assisted Chemical Etching D.M. Pera, University of Lisbon, Lisbon, Portugal |
| 2CV.1.40 Macroscopic Numerical Simulation of the Ozone-Based Wet Chemical Emitter Etch Back for Alkaline Textured Si-Wafers T. Dannenberg, Fraunhofer ISE, Freiburg, Germany |
| 2CV.1.42 Emitter Formation on n-Type Crystalline Silicon Rear Side Using Aluminum Firing and Etching M. Zolfaghari Borra, METU, Ankara, Turkey |
| 2CV.1.43 BBr3 Diffusion: Process Optimization for High-Quality Emitters with Industrial Cycle Times E. Lohmüller, Fraunhofer ISE, Freiburg, Germany |
| 2CV.1.44 High Throughput Low Energy Industrial Emitter Diffusion and Oxidation M. Meßmer, Fraunhofer ISE, Freiburg, Germany |
| 2CV.1.45 POCl3-Based Emitter Diffusion Process with Lower Recombination Current Density and Homogeneous Sheet Resistance for Nanotextured Monocrystalline Silicon with Atmospheric Pressure Dry Etching B. Kafle, Fraunhofer ISE, Freiburg, Germany |
| 2CV.1.46 The Effect of Different Laser Wavelengths on Bifacial Plated Laser Doped Selective Emitter Solar Cells Y.-C. Chang, UNSW Australia, Sydney, Australia |
| 2CV.1.47 Self-Aligned Selective Emitter for PERC based on Inkjetable UV-Polymer R. Efinger, Fraunhofer ISE, Freiburg, Germany |
| 2CV.1.48 Ultra-Thin ALD Grown Al2O3 Capped with SiNx Enabling iVoc Reaching 720 mV on Industrial p-Type Cz c-SI Wafers for PERC Solar Cells M. Zolfaghari Borra, METU, Ankara, Turkey |
| 2CV.1.49 Field Effect Passivation of Plasma Oxidized SiOx Layer Using SiH4/N2O on Boron Doped Emitter Surface by PECVD M.Q. Khokhar, University of Sungkyunkwan, Suwon, Korea, Republic of |
| 2CV.1.50 Newly Developed High-Throughput PECVD Source and Platform for Industrial Production of PERC and TOPCon Silicon Solar Cells F. May, Singulus Technologies, Kahl am Main, Germany |
| 2CV.1.51 Laser Assisted Separation Processes for Bifacial pSPEER Shingle Solar Cells A. Münzer, Fraunhofer ISE, Freiburg, Germany |
| 2CV.1.53 Project "Rock-Star" – High-Speed Rotary Printing for Solar Cell Metallization: From Vision to Reality A. Lorenz, Fraunhofer ISE, Freiburg, Germany |
| 2CV.1.55 Lifetime Analysis of Bifacial-Ready Contacting of Busbarless and Multibusbar Solar Cells for Industrial Mass Production P. Waleska, h.a.l.m. elektronik, Frankfurt am Main, Germany |
| 2CV.1.56 Evaluation of Inline High-Intensity Illumination Treatments Against LeTID H. Vahlman, Fraunhofer ISE, Freiburg, Germany |
| 2CV.1.57 Upgrade Technologies for Silicon Photovoltaics – Part I: Industrial Solution to Minimize the Negative Impact of Light Induced Degradation T. Pernau, centrotherm international, Blaubeuren, Germany |
| 2CV.1.58 Investigation of the Accelerated Degradation and Regeneration Testing for p-Type PERC Cells M.-A. Tsai, ITRI, Hsinchu, Taiwan |
| 2CV.1.59 The International Technology Roadmap for Photovoltaics and the Significance of Its Decade-Long Projections P. Baliozian, Fraunhofer ISE, Freiburg, Germany |
| 2CV.1.60 Efficient Deployment of Deep Neural Networks for Quality Inspection of Solar Cells Using Smart Labeling P. Kunze, Fraunhofer ISE, Freiburg, Germany |
| 2CV.1.61 Screen Utility Simulation - Explaining the Evolution and Future of Screen Printed Metallization of Si-Solar Cells S. Tepner, Fraunhofer ISE, Freiburg, Germany |
| 2CV.1.62 Effect of X-Y Translation Table Speeds to the Optical Absorption of Silicon Solar Cells Textured by Pulsed Nd:YAG Laser N.H. Abdul Razak, National University of Malaysia, Bangi, Malaysia |